L1A1 build on an Enterprise receiver

**ronnymi** · July 29, 2011, 16:45

I have been sitting on this Enterprise Brit cut receiver since November and the Enfield kit for 2 years. I finished my Izzy LB yesterday so since my tools were all out finished the L1A1 today.

Some minor filing on the charging handle rails was the only work required to fit the parts to the upper.

Now I have 2 new builds to test fire at the range.

I cropped out the toes. Sorry.

**ronnymi** · July 29, 2011, 17:04

This is yesterdays project.

Just finished assembling my Izzy LB. I need screws for the rear sling swivel and the tang. I will have to post a WTB. DSA type 1 receiver and new Argy lugged barrel with the gas block changed to an Izzy.

**MajHenryWest** · July 29, 2011, 21:42

Fantastic work. Can't wait to see the range reports.

**DakTo** · July 30, 2011, 07:59

Good job!
Nice to see the old warhorses come back to life.

July 29, 2011, 16:45	#1
ronnymi Senior Member Contributor FALaholic #: 11421 Join Date: Aug 2003 Location: Washington State Posts: 580	L1A1 build on an Enterprise receiver I have been sitting on this Enterprise Brit cut receiver since November and the Enfield kit for 2 years. I finished my Izzy LB yesterday so since my tools were all out finished the L1A1 today. Some minor filing on the charging handle rails was the only work required to fit the parts to the upper. Now I have 2 new builds to test fire at the range. I cropped out the toes. Sorry.

July 29, 2011, 21:42	#3
MajHenryWest Senior Member Gold Contributor FALaholic #: 11906 Join Date: Sep 2003 Posts: 656	Fantastic work. Can't wait to see the range reports. __________________ ****************************** "Steel is Strong because it Knows the Hammer and White Heat." - Johnny Cash, These Things Shall Pass

July 30, 2011, 07:59	#4
DakTo MadMinuteDude Gold Contributor FALaholic #: 9689 Join Date: Mar 2003 Location: The Constitution State Posts: 5,424	Good job! Nice to see the old warhorses come back to life. __________________ Never Take A Pistol To A Gun Fight!

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

July 29, 2011, 17:04	#2
ronnymi Senior Member Contributor FALaholic #: 11421 Join Date: Aug 2003 Location: Washington State Posts: 580	This is yesterdays project. Just finished assembling my Izzy LB. I need screws for the rear sling swivel and the tang. I will have to post a WTB. DSA type 1 receiver and new Argy lugged barrel with the gas block changed to an Izzy.